Local water treatment service

Water Treatment in St. Petersburg, FL

Free in-home water testing and straight answers for hard water, stains, odor, sediment, and whole-house filtration in St. Petersburg.

158 mg/L
Hardness, 2025 city average — about 9.2 grains per gallon
3.73 ppm
Chloramine — 93 percent of the 4.0 cap
1.8 ppb
Lead, 90th percentile — well under the action level of 15
about 10 billion gallons
treated at the city’s Cosme plant in 2025

City of St. Petersburg 2025 water quality report — every figure is sourced in full below.

Main water line entering the house at the installation tie-in point — the kind of owner-installed system Aqua Pro fits in St. Petersburg homes
Real install · No stock photosThe main water line entering the house — where we tie in.

What St. Petersburg water looks like

St. Petersburg runs its own water utility but owns no water source. Every drop is bought from Tampa Bay Water, the regional wholesaler, and treated at the city’s own Cosme Water Treatment Plant in northwest Hillsborough County — about 10 billion gallons in 2025. The blend changes with the weather: groundwater from Floridan Aquifer well fields, surface water from the Alafia and Hillsborough rivers, the C. W. Bill Young Regional Reservoir and the Tampa Bypass Canal, and desalinated seawater from Hillsborough Bay. At Cosme the water gets aeration, lime softening, chloramine disinfection, and filtration — which is why St. Petersburg’s published hardness runs lower than its neighbors’. This fall, that changed.

On September 4, 2026, the city told its own customers to expect harder water for a while. Southwest Florida is in a severe drought, so Tampa Bay Water shifted the blend toward groundwater, which is naturally harder — and at the same time, the decades-old softening equipment at Cosme went offline for a major rehabilitation. Starting September 8, the city began adding a blended phosphate treatment to protect pipes and offset the extra mineral deposits and occasional rust-colored water. Read the city’s 2025 averages below with that in mind: they describe last year’s softened water. What reaches your tap while the softening equipment is down can run harder, and the city says so itself.

The city’s 2025 report publishes its own commonly requested results: hardness averaged 158 milligrams per liter — about 9.2 grains per gallon, hard water even with lime softening running — alongside a pH of 8.2 and alkalinity of 125 milligrams per liter. The chloramine disinfectant hit a highest running annual average of 3.73 parts per million against a maximum residual disinfectant level of 4.0 — 93 percent of its cap, with individual samples ranging from 0.60 to 5.60. The byproducts that chloramine forms stayed comfortable: haloacetic acids at 21 parts per billion against a limit of 60, and total trihalomethanes at 23 against a limit of 80.

What is not the story here: lead and violations. The system’s 90th-percentile lead reading is 1.8 parts per billion, well under the federal action level of 15, and copper read 0.43 parts per million against an action level of 1.3 (both from summer 2023 tap sampling). The city reported no maximum contaminant level violations in 2025, and its service-line inventory found no lead service lines. One honest exception, and it is a cosmetic one: in the Tampa Bay Water wholesale results printed in the city’s report, foaming agents read 1.8 parts per million against a secondary standard of 0.5 — a taste-and-appearance standard, not a health limit. I will tell you when a number is fine, not just when it is not.

Those are system averages from a year when the softening plant was running. Your tap this fall is a different sample. The free 20-minute test covers hardness, iron, chlorine, pH, sulfur, and total dissolved solids (TDS) at your tap. And do not confuse this system with the county’s: St. Petersburg is not on Pinellas County Utilities water — the Pinellas County water quality results describe your neighbors’ supply, not yours.

Your tap, not the system average

See what St. Petersburg water is doing in your home.

The free test takes about 20 minutes at your tap. No obligation and no sales pitch — just your numbers, explained against the legal limits.

How we help in St. Petersburg

Licensed & Insured · Locally owned · Owner-installed

Start with the free test

Every recommendation follows a 20-minute test at your tap — never a sales pitch.

Step one · 60 seconds

The quick water check

Answer a few questions about what your water is doing at home.

Take the 60-second water check
Step two · 20 minutes

The free test at your tap

Hardness, iron, chlorine, pH, sulfur, and total dissolved solids — measured at your home, explained on the spot.

Book your free test

Find Out What’s in Your Water—Free.

Pick a callback time. We’ll call you back as soon as possible during business hours.

Licensed & Insured · Locally owned · Owner-installed

No obligation and no sales pitch. The test takes about 20 minutes at your tap.